Graph of the Day: California sets daily records for utility scale solar

EIA

On June 1, 2014, the California Independent System Operator (CAISO) recorded a record midday hourly peak of 4,767 megawatts of alternating current (MWAC) of utility-generated solar electricity delivered into the California grid.

With rapidly growing utility-scale solar capacity, CAISO has regularly recorded new hourly output records going back to 2010 when it first began publishing the daily data. When the hourly data are averaged over the course of a month to control for weather variation, the average peak hourly generation in May 2014 of 4,086 MWAC was 150% greater than the level in May 2013.

In 2013, 2,145 MW of utility-scale solar capacity entered service in California, of which more than 500 MW came from large-scale solar thermal plants. California accounted for more than 75% of U.S. utility-scale solar capacity installed in 2013.

Total solar electricity output in May 2014 constituted 6% of the total CAISO electricity load that month, compared with 2% in May 2013. However, during the average peak solar output hour, between 11:00 a.m. and noon for May 2014, solar supplied 14% of total power, compared with 6% in May 2013.

Solar generation facilities generally provide power to the CAISO grid from early morning until the evening, and reach peak output around midday. When solar electricity is being generated, less electricity from other sources such as natural gas or interstate electricity imports is required. Conversely, when there is little-to-no solar generation, the shares of other fuels used in California’s supply mix rise.

Source: CAISO Daily Renewables Watch Note: This chart shows a set of 24 hours for each month, calculated from CAISO’s average hourly output data by taking the average output for each hour in a given month. The peaks therefore do not exactly correspond to actual peak outputs, but should approximate the average peak hourly output in a given month. Note: The fuels above generally reflect CAISO’s categorization of renewable fuels that meet the eligibility requirements of California’s Renewable Portfolio Standard. Small hydroelectric includes facilities with generation of 30 megawatts or less. (EIA defines all conventional hydroelectric generation as renewable.)

While solar generation follows a relatively consistent pattern throughout the day (see tab 1), CAISO also faces challenges in integrating other renewables (see tab 2). Wind output during the summer months frequently coincides with the afternoon and evening peak demand hours, but it is also an intermittent resource and therefore has a limited ability to provide firm capacity. Hydroelectric power, which provides 12% of California’s net generation, is typically a flexible, dispatchable resource—but is also subject to seasonal variability, drought effects, and restrictions on dispatch created by the needs of other water users.

Solar and renewables still constitute a relatively small share of generation for California in the context of all fuel sources (tab 3). Natural gas accounted for 59% of net generation in 2013, and 3,940 MW of new natural gas capacity came online in 2013, which will help address some of the reserve capacity needs for balancing renewables, as well as replace some of the baseload power that was lost when two of the state’s fournuclear units were retired in 2012.

California’s utilities are less than two-thirds of the way toward meeting their 2020 RPS goals. With declining solar manufacturing costs, and the federal investment tax creditin place through the end of 2016, utility-scale solar installations are expected to continue through 2014. Projects currently reporting to EIA have indicated plans for an additional 1,728 MWAC of new utility-scale solar to be installed between May and December 2014.

In addition to leading the nation in utility-scale solar capacity, California also has a significant level of behind-the-meter residential and commercial solar photovoltaic (PV) capacity. According to the Solar Energy Industries Association, approximately 700 MWDC of residential and commercial/industrial solar PV capacity was also installed in California in 2013, further reducing midday baseload power demand.

Source: EIA. Reproduced with permission.

Recent Posts

NSW takes lead on mandatory solar panel recycling as ministers call for urgent action on rising tide of waste

NSW takes lead on mandatory recycling for solar panels that could set a national benchmark,…

21 September 2026

Huge hybrid wind project gets final green tick, but must use tall turbines to avoid black cockatoos

EPBC waves through 2 GW wind, solar and battery project proposed for Australia's biggest isolated…

21 September 2026

Renewables hit more than 80 pct of grid demand for first time – despite heavy throttling of wind and solar

Updated: Renewables met more than 80 per cent of total grid demand for first time…

19 September 2026

Explainer: Who will set Australia’s rules for home energy devices such as solar, plug-in batteries and EVs?

A new Consumer Energy Resources Technical Code will define the standards and capabilities required of…

19 September 2026

Businesses “do the math” and want to go electric – right up until they try to connect to the grid

Australian businesses looking to ditch gas and diesel can do the sums, find electrification will…

18 September 2026

Wind and solar hit record share of Australia’s main grid, nearly half of it from rooftop PV

An abundance of rooftop solar generation has helped set a new record high for the…

18 September 2026