Avoiding the peak: The value of grid-connected power storage | RenewEconomy

Avoiding the peak: The value of grid-connected power storage

Print Friendly, PDF & Email

A new study by the ATA weighs up the value of using grid-connected battery storage, charged during off-peak, for use during peak events.

share
Print Friendly, PDF & Email

The Alternative Technology Association recently conducted research into the value proposition of stand-alone power systems (SAPS) as an alternative to network augmentation in remote areas of the electricity grid.

In discussing the findings with ATA members and the broader energy industry, the main questions that people asked us were:

– How can I utilise energy storage to meet peak demand?

– When will it be viable to get rid of my electricity supplier and totally disconnect from the grid?

For homes with typical levels of energy consumption (i.e. in the order of 10 – 30 kWh per day), the ATA SAPS research demonstrated that for the purposes of complete disconnection, the capital and levellised cost of a SAPS is, in the short to medium term, likely to remain prohibitive for the majority of consumers wanting to completely isolate themselves from the grid.

ATA has now modelled the value proposition to a customer of using grid-connected battery storage, charged from the grid during off-peak times for use during peak events.

The ATA has considered a scenario where a fixed, constant load during the peak period was supplied by batteries charged during the off-peak period.

The constant load selected was 2kW and the duration was 6 hours. 260 peak periods were also selected for the initial scenario, which reflect all weekday afternoon peak periods for one calendar year (and when peak retail rates are likely to apply). An analysis period of 15 years was used, to reflect the life expectancy of well maintained batteries that are not excessively discharged.

Table 1 below outlines the other fixed parameters selected for the initial scenario:

1. Includes: metering, smarts, switching gear and installation
2. 77% = Charger (95%), Battery Bank (85%), Inverter (95%).

ATA chose lead acid batteries for the modelling exercise. In theory, with lithium-ion phosphate batteries being around twice as expensive as lead acid, but with the ability to be cycled twice as deeply (i.e. 100%), the resultant cost of energy provided by both battery types would be broadly similar, for the purposes of the modelling.

Table 2 below lists the capital costs for the battery system based on the above parameters:

ATA then set about researching current time-of-use (ToU) tariffs that are available, in order to understand the costs of charging batteries during off peak times, and the value of the benefit of using them during peak times.

A quick analysis of price comparator websites suggested that NSW has the highest peak electricity tariffs in Australia – with some peak rates rising as high as 58.85 cents per kWh (after GST) over a 6-hour period from 2pm to 8pm. This tariff value is not surprising given the level of network investment currently happening in NSW.

So using the NSW tariffs as a guide, and including forecast increases in electricity prices for NSW, the ATA calculated the necessary retail tariff rates to achieve a positive net present value within a 15 year analysis period. This included consideration of both the off-peak rate (paid to charge the batteries); and the peak rate (to be avoided by drawing on the battery bank).

On the basis of the fixed parameters above, we found that when the off-peak tariff is in the range of 10 to 14 cents per kWh (consistent with the current offerings in NSW), the peak tariff must be at least 36 cents per kWh higher than the off-peak tariff (i.e. in the order of 50 cents per kWh) for the investment to break even over 15 years. This analysis assumes that the peak tariff is constant over the 6-hour period, as is the case with the NSW tariffs mentioned above.

The results of how long it takes to payback the investment based on different peak/off-peak tariffs is shown in Table 3 and Figure 1 below:

4. All assume a 6 hour peak. As peak tariffs get higher and the differential greater, peak durations are likely to get shorter which may affect payback times. As an example, based on a differential of 50 cents and only a 2 hour peak duration, with all other parameters constant, the payback rises to 12 years

As shown above, to obtain a shorter payback to the customer of under 7 years, the tariff structure would have to include a peak to off-peak tariff difference of at least 65 cents per kWh. The difference between the two scenarios in Figure 1 reflects the assumption that peak tariff rates will increase slightly more than off-peak tariff rates over the analysis period.

It should be noted that for all but the most expensive ToU tariffs currently available in NSW (and likely in the rest of the country), the difference between the peak and off-peak tariffs is not currently high enough to warrant this type of investment.

In more remote locations at the end of long powerlines, the business case for grid-connected battery inverter systems may not rely purely on the tariff rates, but also on the benefit of the avoided cost of an upgraded connection for a customer who is looking to increase their electrical capacity.

As the market for ToU evolves, it is likely that tariffs with high enough differentials between the peak and off-peak will be seasonal (i.e. may only be high enough in summer) and will likely have a shorter peak duration (probably 2 or 4 hours). Consumers will need to be aware of this in considering different tariff options.

And how could distributed generation such as solar be considered in the above scenario?

The off-peak rate for charging the battery bank can be thought of as the required levellised cost that electricity from a solar PV system must reach for a grid connected solar-battery system to achieve the same NPV or return on investment.

Given the NSW context above, a 1.5 kW system installed in Sydney currently having an installed cost of $2.70 per watt before STCs, has a levellised cost of energy of 13.7 cents per kWh, after STC incentive and over the life of the system.

But with solar being potentially able to contribute directly to consumption during peak periods and the options around storing more solar energy with a larger battery bank – this proposition needs further modelling.

So stay tuned for ATA’s next article where we will model the inclusion of solar with a grid-connected battery system!

Damien Moyse is Energy Projects & Policy Manager at the Alternative Technology Association – www.ata.org.au

Print Friendly, PDF & Email

1 Comment
  1. Peter 8 years ago

    Dear Damian,

    As always a perspicacious article. The greater developments would be when the panel owners also has an electric car; using the battery to store excess electricity. They would need to make behavioural adaptation; but for those many who have a car for short local trips, with the added potential fuels savings, this battery use as additional storage, could tip the balance in their favour, significantly. A Model of such a scenario would be captivating.

    Regards

Comments are closed.

Get up to 3 quotes from pre-vetted solar (and battery) installers.